(C) 2010 American Institute of Physics. [doi:10.1063/1.3514549]“
“Gelatin was extracted from chrome tanned leather waste with the aim to produce a durable coating or film. Crosslinking has shown to improve the physical performance of a film/coating. The effect of the method of crosslinking and the use of different crosslinking agents were studied. The extracted gelatin was crosslinked either by immersion

of preformed films into LOXO-101 purchase a crosslinker solution (Method A) or by the addition of the crosslinking reagent to the gelatin solution prior to film formation (Method B). The different results obtained between both methods may be due to: the relative concentration of crosslinking reagent, Y 27632 the introduction of crosslinks within different regions of gelatin (triple helical regions and random coil regions), and the reaction rate. Method A of crosslinking is more likely to form crosslinks outside but close to the triple helical regions, disrupting the order and stability of the helical structure. Crosslinks may form preferentially within

the random coil regions when Method B of crosslinking is used. Both methods led to the formation of chemical crosslinks in the extracted gelatin films, as demonstrated by the reduction of the degree of aqueous swelling and the proportion of low molecular weight fractions. (C) 2010 Wiley Periodicals, Inc. J Appl Polym Sci 119:2105-2111, 2011″
“Using in situ resistance measurements on diamond anvil cell, we have monitored the pressure and temperature dependence of the CaB6 electronic transport properties. We report that CaB6 is a semiconductor at room temperature and at ambient pressure,

in contrast to previous click here studies suggesting a semimetal nature. From ambient pressure to 12 GPa, the CaB6 conductivity smoothly increases, and CaB6 behaves as a semiconductor, although the CaB6 conductivity shows a metallic temperature dependence over a temperature interval ranging from 110 to 300 K due to its extrinsic region (where an increase in the temperature produces no effect on the CaB6 sample carrier densities and the CaB6 conductivity is, therefore, solely determined by the carrier mobilities). At around 12.4 GPa, CaB6 undergoes a metalliclike transition leading to a change in the CaB6 conductivity by a factor exceeding three orders of magnitude. This large increase in the CaB6 conductivity has been interpreted as resulting from an overlap between the conduction band and the valence band. From 12.4 to 26 GPa, the CaB6 conductivity markedly increases and is similar to a metallic one. (C) 2010 American Institute of Physics. [doi:10.1063/1.3510586]“
“Melt blowing involves applying a jet of hot air to an extruding polymer melt and drawing the polymer stream into microfibers. This study deals with the dynamic modeling of the instabilities and related processes during melt blowing.