Especially, Autophagy pathway inhibitor when using the CTAB agent, the dispersion of the sample was much better with the smallest size of particles of about 2 to 4 nm. The result
indicates that the CTAB surfactant has coated uniformly the surface of the material giving it much better dispersion in suspension. Effect of surfactant concentration on the particle size distribution of silica nanoparticles In order to optimize the formation condition of silica nanoparticles, the effect of the CTAB concentration was investigated. The experiments were performed varying its concentration from 0 to 3 wt.% of total mass of silica, and the aging time and aging temperature condition are fixed at 8 h and 60°C, respectively. The TEM micrographs of silica nanoparticles obtained at different CTAB concentrations are exhibited in Figure 3a,b,c,d,e,f. It can be clearly seen that the formed silica particles buy Opaganib were seriously aggregated and the size ranged from a few nanometers to several hundred nanometers. In increasing the concentration of surfactant from 0.5 to 2.0 wt.% (Figure 3a,b,c,d), the particle size and uniform dispersion can be achieved. Above this concentration value of surfactant, the particle size becomes larger and causes aggregation. This suggests that 2 wt.% CTAB is the best surface-active
substance to protect the surface of silica, in which silica nanoparticles are uniform (Figure 3d), which leads to the combination of silica and CTAB dispersed completely in the butanol solvent, as shown in Figure 4b (no polar hydrophilic agent). When the CTAB concentration was increased from 2.5 to 3.0 wt.% as shown in Figure 3e,f, the results show the appearance of small particles, while being distributed synchronously unclear, which tend to agglomerate, and silica nanoparticles were not distributed
in the butanol solvent when the concentrations of CTAB were increased (Figure 4a). Figure 3 TEM micrographs of silica nanoparticles obtained from CTAB. 0.5 (a), 1.0 (b), 1.5 (c), 2.0 (d), 2.5 (e), and 3.0 wt.% (f). Figure 4 Silica nanoparticles dispersed in water/butanol. Effect of aging temperature and time on the particle size and its distribution of silica nanoparticles Achieving the particle size and its distribution of silica nanoparticles www.selleck.co.jp/products/MDV3100.html depends on the stability of silica sol. Derjaguin [24] had distinguished three types of stability of colloidal systems: (1) phase stability, analogous to the phase stability of ordinary solutions; (2) stability of disperse composition, the stability with respect to the change in dispersity (particle size distribution); and (3) aggregative stability, the most characteristic for colloidal systems. Colloidal stability means that the particles do not aggregate at a significant rate. As explained earlier, an aggregate is used to describe the structure formed by the cohesion of colloidal particles.