In both analyses, the T-RFs were standardized (centered and 1/SD) prior to the modeling phase to ensure that all

of them would equally influence the models, and possible outliers were Ilomastat manufacturer inspected visually and with Hotelling T 2 . The diversity index was calculated as https://www.selleckchem.com/products/bmn-673.html described previously [26]. In brief, the Shannon-Weaver index of diversity (H’) based on all of the initial T-RFs was used to determine the diversity of the bacterial fragments. Group comparisons of the diversity index in cloned versus non-cloned controls were calculated at each of the sampling points. As the Shannon-Weaver index was not normally distributed, Mann Whitney U test and Spearman correlation were applied. The H’ values are represented in figures as mean and error bars representing standard deviations (SD). Dice similarity between groups based on all the T-RFs were calculated in BioNumerics (Applied Maths, Kortrijk, Belgium) and the results are presented

as mean values. T-RFs in the figures are presented as mean and standard error of the mean (SEM). A significant difference was considered VS-4718 clinical trial when P-value was less than 0.05 (P<0.05). Fecal samples and bacterial strains for qPCR The extracted DNA from the fecal samples used for the T-RFLP analyses were also analyzed by qPCR, but only samples taken monthly were chosen for qPCR analysis. However additional sampling points two weeks before the endpoint samples were also analyzed by qPCR. Three bacterial strains (Clostridium perfringens (NCTC 8449), Odoribacter splanchnicus (isolate DJF_B089) and Escherichia coli (ATCC 25922), representing the Firmicutes and Bacteroidetes phyla and general bacteria, respectively, and six randomly chosen extracted DNA samples (divided equally into clones and controls) were used to optimize the PCR conditions. qPCR primers and conditions The 16S rRNA gene DNA primers for Bacteroidetes and Firmicutes used in this study were designed by Baccetti De Gregoris et al.[27] and conditions were optimized for the thermocycler used (Rotor-Gene Q Real Time PCR cycler (Qiagene)). The

universal primer used in this study had an amplicon length of 147 bp (S-D-Bact-0907-a-S-20 5’-AAACTCAAAGGAATTGACGG-3’; S-D-Bact-1054-a-A-20 5-’ ACGAGCTGACGACAGCCATG-3’) Chlormezanone [12]. The specific primer sets for Bacteroidetes (798cfbF 5’ CRAACAGGATTAGATACCCT’3 and cfb967R 5’ GGTAAGGTTCCTCGCGTAT ‘3) and Firmicutes (928F-Firm 5’ TGAAACTYAAAGGAATTGACG ‘3; 1040firmR, 5’ ACCATGCACCACCTGTC ‘3) had an amplicon length of 240 bp and 200 bp, respectively [27]. All qPCR reactions contained 12.5 μl of SYBR® Green JumpStart™ Taq ReadyMix™ without MgCl2 (Sigma-Aldrich, Copenhagen, Denmark), 0.3 μmol l-1 of each primer and 5 μl of template DNA adjusted to 5 ng μl-1. MgCl2 optimization was performed and a final concentration of 2.5 mM MgCl2 was chosen. The annealing temperature was optimized by using 16S rRNA gene DNA extracted from fecal samples and DNA extracted from different bacteria.