These techniques include thermal evaporation [5, 29], hydrothermal [2, 3] and electrochemical deposition [4], and metal-organic vapor-phase epitaxy (MOVPE) [1]. In this paper, we report the seed/catalyst-free growth of ZnO structures on multilayer (ML) graphene by thermal evaporation. The dependence of substrate temperatures on the properties

of grown structures was studied. Based on the obtained results, a growth mechanism was proposed. Methods A ML graphene on SiO2/Si (Graphene Laboratories Inc, Calverton, NY, USA) was learn more used as a substrate. Figure  1a shows the measured Raman spectra of the ML graphene. The 2D peaks at approximately 2,700 cm-1 of the Raman spectra for graphite as shown by locations 1 and 4 have broader and up-shifted 2D band indicating few layer graphene [30]. Figure  1b shows the schematic of the experimental setup. The growth was carried out by thermal evaporation PF-01367338 research buy technique in dual zone furnace. High-purity metallic Zn powder (99.85%) and oxygen (O2) gas (99.80%) were used as the sources. Prior to the growth process, the substrate was treated with organic cleaning of ethanol, acetone, and deionized (DI) water to remove any unwanted impurities on the substrate. Zn powder of approximately 0.6 g was spread evenly into a ceramic boat. The ceramic boat was placed in the zone 1 of the furnace, while the substrate was placed inclined at 45°

in the zone 2 of the furnace. The distance between source and substrate was fixed at 23 cm. Two independent temperatures were applied to the Selleck NCT-501 furnace system. Here, T1 denotes to the set temperature (ST) of the source while T2 denotes to the ST of the substrate. Firstly, the temperature of zone Clomifene 2 was raised to T2 (i.e., 600°C, 800°C, or 1,000°C) in argon (Ar) environment (Ar flow rate of 200 sccm).

Then, the temperature of zone 1 was raised to T1 (1,000°C). The flow of Ar was stopped when the temperature of zone 1 reached 400°C (Zn melting point, 419°C). This was done in order to avoid the transfer of Zn particles to substrate prior to actual growth. The heating of Zn powder was continued until it reached 1,000°C. It was confirmed from several attempts that such high temperature was needed for continuous and constant evaporation of Zn. After reaching 1,000°C, O2 (400 sccm) was introduced for 1 h of growth time. Finally, the furnace was turned off and the samples were cooled down to room temperature. Figure  1c summarizes the growth procedures. The as-grown ZnO was examined using field-emission scanning electron (FESEM) microscopy (SU8030, Hitachi, Chiyoda, Tokyo, Japan), dispersive X-ray (EDX) spectroscopy, X-ray diffraction (XRD) (Bruker, AXES, D8 Advance, Bruker Corporation, Billerica, MA, USA) and photoluminescence (PL) spectroscopy (Horiba JobinYvon, Tokyo, Japan). Figure 1 Raman spectra of ML graphene (a), schematic of growth setup (b), and growth time chart (c).